5 Series E34 518g (M43) TOUR
13 41 500
Replacing idle speed control valve (M43 from
9/95, M43TU, M44)
Turn off ignition.
Disconnect plug connection (1).
Detach hose from vacuum connection (2).
Release screws (3) and remove idle speed controller.
Check sealing face and seal of idle speed control valve for
damage. Clean sealing face and if necessary replace seal.
Installation:
Clip supply line of idle speed control valve into retainer (1) on
intake hose.
Read out fault memory of control module of Digital Motor
Electronics (DME), check stored fault messages, rectify faults,
cancel fault memory.
RA Replacing idle speed control valve (M43 from 9/95, M43TU, M44)
BMW AG - TIS
15.01.2013 13:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -