5 Series E34 518g (M43) TOUR
13 83 510
Replacing CNG gas density sensor
Draining the CNG system,
refer to section on draining the CNG system
After draining the system, switch off the ignition.
Unscrew and remove gas density sensor from connection on gas
bottle; it is essential to brace the stop cock on the gas bottle with a
wrench to prevent leakage at the stop cock and from the gas
bottle.
Avoid damaging the O-ring (1). Ensure that grommet (2) is not
damaged and that the nut (3) is fitted.
Installation:
Tightening Torque, refer to
Technical Data 13 83 2AZ
When tightening the gas density sensor, always brace stop
cock on gas bottle with wrench to prevent leakage at the stop
cock and from the gas bottle.
Installation:
Perform leak and pressure test,
refer to 13 80 600
RA Replacing CNG gas density sensor
BMW AG - TIS
15.01.2013 13:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -