5 Series E34 518g (M43) TOUR
Operation
The Run Flat Indicator (RPA) is initialised using the following control elements:
-
RPA button
-
On-board computer button on turn-signal/main-beam switch
-
With iDrive in the Central Information Display (CID) with the controller
Important: Always perform initialisation immediately after correcting the tyre pressure, especially if a tyre is
changed or the wheels are interchanged. Only check tyre pressures when the tyres are cold.
Set the tyres to the correct pressure before performing initialisation. During initialisation, the set tyre pressure
is taken as the initial value for the current set of wheels.
Correct the tyre pressures when the tyres are cold to prevent the data recorded from being affected by
temperature.
Important: Responsibility resides with the driver at all times
Check tyre pressures regularly, at least twice a month and before embarking on lengthy journeys. During
initialisation, the set tyre pressure is taken as the initial value for the current set of tyres.
Initialise the RPA in the following situations:
-
If tyre pressure is changed
(tyre pressure is corrected or reset)
-
If the position of the tyres is changed (change of axles, wheels), even if the tyre pressure is not changed
-
If a tyre is changed or the wheels are interchanged
(e.g. old tyres for new tyres, summer tyres for winter tyres, etc.)
Start initialisation as follows:
-
Terminal 15 ON
(engine OFF or ON, do not pull away)
-
Vehicles with RPA button
•
Press and hold the RPA button until the RPA indicator and warning light lights up yellow for a few seconds
-
Vehicles with BC button (on-board computer function)
•
In the on-board computer function select "RPA" and "INIT" (LCD display) with the rocker switch on the turn-
signal/main-beam switch. Press the BC button to confirm.
•
Press and hold the BC button for approx. 5 seconds, until a box with a tick appears behind the "INIT"
display.
> R56:
•
In the on-board computer function select "SET/INFO" (LCD display in auxiliary instrument) with the BC
button on the turn-signal/main-beam switch.
•
Press and hold the BC button until the display changes
•
Press the BC button repeatedly until the corresponding symbol and the word "RESET" are displayed.
•
Press and hold the BC button until a square with a tick appears.
-
Vehicles with Central Information Display
Initialisation is performed via the Central Information Display (CID) and controller.
•
Select "RPA" in the "Settings" menu and confirm.
SBT Run Flat Indicator All models
BMW AG - TIS
15.01.2013 20:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -