5 Series E34 518i (M43) SAL
Remove 2 bearing pins on right.
Note:
Bearing pins must be replaced.
Remove 3 bearing pins on left.
Note:
Bearing pins must be replaced.
Remove locking lever (1) completely.
Remove pressure spring (2) and thrust pin (3).
Remove screw (4).
Remove reverse gear wheel with needle bearings, thrust washer,
pin and half shell.
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
17.01.2013 14:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -