5 Series E34 524td (M21) SAL
Install shim of thickness
1.60 mm
and measure again.
Remove differential.
Match side covers and shim of determined thickness, and do not
mix them up.
Installation:
Clean tapped bores thoroughly (tapper).
Heat plate spring to max. 100
°
C (thermo-chrome pin).
Mount crown wheel with two locally manufactured staybolts for
guiding.
Install new bolts with Loctite No. 270. Tighten bolts in order of 1 ...
10).
Tightening Torque and torsion angle,
refer to Technical Data 33 12 1AZ.
Install differential with crown wheel and pulse gear.
Install side cover after marking with the appropriate washers (1)
and new O-rings (2).
Tightening Torque,
refer to Technical Data.
RA Replacing both bearings on final drive housing (Type M) - final drive removed -
BMW AG - TIS
19.01.2013 22:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
