5 Series E34 525td (M51) TOUR
If necessary, replace connecting rods.
The BMW Parts Service only supplies connecting rods in
complete sets.
Note:
It should be possible to press piston pin into bush by hand
using only slight pressure. Clearance should then be minimal.
Replace conrod bearing,
refer to 11 24 571.
Fit the connecting rod to the piston in such a way that, when the
pair number is visible, the installation arrow on the piston points to
the right.
Caution!
Piston and piston pin are paired and must not be fitted
individually.
Fit the retaining ring with its aperture opposite the recess.
Caution!
Re-install piston, connecting rod and bearing shells back in
the same position and in the same installation location.
Connecting rods and bearing covers are designated with the
same pair number: do not mix them.
RA Removing and installing or replacing all pistons (M51)
BMW AG - TIS
23.01.2013 06:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
