Replacing Bearings on Transmission Shafts for 5 Series E34 525td (M51) TOUR
Drive out ball bearing for output shaft with special tool 23 1 440
towards inside.
Countershaft:
Heat housing in area of ball bearing to approx. 80
°
C (hot-air
blower).
Withdraw ball bearing (1) towards inside.
Clean dirt from rear housing section.
Heat rear section of housing uniformly in area of ball bearing to
approx. 80
°
C (hot-air blower).
Insert ball bearings for output shaft/countershaft.
Insert ball bearing (1) for countershaft with stepped side (1)
towards inside.
Drive in ball bearing until it is firmly seated:
-
Drive in output shaft with special tools 23 1 470 and
00 5 500 .
-
Drive in countershaft with special tools 23 1 220 and
00 5 500 .
RA Replacing bearings on all transmission shafts (S5D 260Z / 310Z / 320Z)
BMW AG - TIS
23.01.2013 07:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
