5 Series E34 525td (M51) TOUR
Detach 1st/2nd gear sliding sleeve.
Caution!
Loose thrust pieces, balls and springs.
Lever out retaining ring (1).
Remove spacer (2).
Installation:
Replace retaining ring (1).
Position press-off supports on 2nd gear wheel.
Press guide sleeve, 2nd gear wheel with synchronizing
mechanism and needle bearings off output shaft.
Assembling gear train:
Fit needle bearings and 2. gear wheel with recesses facing
upwards.
Attach synchronizing mechanism.
Consisting of:
Place the inner race (1), intermediate ring (2) with drives (3) in the
recesses of the 1st gear wheel and synchronizer ring (4).
RA Disassembling and assembling all synchronizing mechanisms (S5D 260Z / 310Z / 320
BMW AG - TIS
23.01.2013 07:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
