5 Series E34 525td (M51) TOUR
Clamp special tool 24 1 180 on stator shaft.
Remove oil supply line from transmission case.
Installation:
Replace O-ring (1).
Replace damaged rectangular rings (2).
For ease of installation, coat O-ring (1) and rectangular rings
(2) with Vaseline.
Push the rectangular rings (2) flush into the grooves.
Suction and pressure ducts in oil supply unit must be aligned
with bore in transmission case.
Caution!
If the rectangular rings (2) are too high, they can be damaged
during the installation of the oil supply unit.
Remove adjusting disc (1), needle bearing (2) and angle disc (3).
Installation:
End float is adjusted with shim (1).
Installation:
Adjust end float:
Install and tighten down oil supply unit.
Secure special tool 24 0 012 to stator shaft.
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
23.01.2013 07:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
