5 Series E34 525td (M51) TOUR
Remove shim (1) and sprag wheel (2).
Installation:
End float is adjusted with the shim (1).
Adjust end float,
refer to 24 13 156
Arrange transmission vertically with output end facing downwards.
Unscrew bolts.
Installation:
Tightening torque,
refer to Technical Data 24 22 1AZ.
Screw special tool 24 1 260 into planetary gear set, tighten
down knurled screw.
Note:
Cylinder D/E (1) and the planetary gear set are held together
by tightening down the knurled screw.
Lift out complete unit with a workshop crane and place on two
wooden blocks.
Installation:
Twist spline (2) with a screwdriver until it locates in housing of
planetary gear set (1).
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
23.01.2013 07:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
