5 Series E34 525td (M51) TOUR
Screw tightening specification,
refer to Technical Data 24 22 1AZ
1.
Install all three screws handtight.
2.
Preload center screw with 30 Nm.
3.
Preload both outer screws with 15 Nm then tighten down to
30 Nm.
4.
Tighten all screws to 63 Nm, starting on the center screw.
Caution!
If parts of brake/clutch unit "D/G" are replaced, the spacer
disc must be recalculated.
Rotate transmission through 180
°
(output side facing upwards).
Place transmission extension on vise jaws.
Output flange must not bear.
Press output flange in direction of output.
Measure distance (A) from collar to screw connection face
and distance (B) from collar to contact face on output flange.
Calculate gap between screw connection face and contact face on
output flange, distance (C):
Example:
-
A = 10.0 mm
-
-B = 7.4 mm
-
==========
-
C = 2.6 mm
RA Replacing multi-disc brakes D/G
BMW AG - TIS
23.01.2013 07:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
