5 Series E34 525td (M51) TOUR
33 14 520
Replacing complete locking differential
(Type M) - final drive removed -
Removing and installing final drive, included in Repair Manual MF,
model-dependent, from '85,
refer to 33 10 010.
Drain ATF.
Secure final drive to special tool 33 1 010 (retaining bracket).
Installation:
Add oil.
Oil volume, refer to Technical Data
Refer to Fluids and Lubricants for approved oil.
Take off case cover.
Installation:
Replace gasket.
Tightening torque, refer to Technical Data
Press off both drive flanges with a tire iron.
Installation:
Place round wire snap ring (1) in groove of differential case
prior to installation of the drive flange, that both ends are
recessed in the groove. This prevents lateral bending of the
ring.
Press in drive flange by hand and turn slightly until wire snap ring
is heard to engage.
Replace stretched snap rings.
RA Replacing complete locking differential (Type M) - final drive removed -
BMW AG - TIS
23.01.2013 07:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
