bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

1 RA Instructions On Gluing Windscreen|Page 1002 > < 1 RA Instructions On Gluing Windscreen|Page 1000
Page 6
background image

Hot cementing:
 -  83 19 0 147 370
Cold cementing:
 -  83 19 0 147 369
Adhesive cartridge:
-  83 19 0 152 031

a)

Clean with spirit (available in pharmacies).

b)

Observe an air drying time of at least 1 minute

c)

Apply a thin coating of "Glass Activator 1"

d)

Observe an air drying time of at least 10 minutes

Version with inspection window for vehicle identification number in windscreen only (all except US/GB):

Seal inspection window (bottom left) with Sika primer 206 G+P

 

Adhesive quantities:

Approx. 1 1/4 adhesive cartridges are required to cement the windscreen on the following vehicles:

7 Series

5 Series from E60

X5

X3

In the case of hot cementing (with accelerator), the missing residual bead is applied from a second adhesive cartridge
(not contained in the repair kit) but while cold and without accelerator (bubbling). 

Minimum hardening period is thus not increased.

Important!

If a second cartridge is required for cementing:

First apply cold adhesive to cowl panel at bottom (skin formation time)

Accelerator from repair kit must not be used with the second cartridge (bubbling)

Bubbling results in leakage and insufficient bonding strength (torsional rigidity, passenger airbag).

 

Effect of differing adhesive quantities:

Too little adhesive:

Too much adhesive:

Windscreen rests too low in body cutout

Strains/tensions may occur (windscreen breakage)

Insufficient squeezing of adhesive bead (leaking)

Windscreen rests too high in body cutout

Wind noise may occur

Strains/tensions may occur (windscreen breakage)

Fouling of add-on parts by emerging adhesive

Adhesive on uninsulated strainer pressure lines of

aerial(s) (interference of reception)

 

Spacer buffers:

Before sticking on new spacer buffers, remove all remaining traces of old spacer buffers completely.

Position of spacer buffers must be observed exactly. 

Incorrectly fitted spacer buffers will result in:

RA  Instructions on gluing windscreen

BMW AG - TIS

23.01.2013  08:00

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 6 -

1 RA Instructions On Gluing Windscreen|Page 1002 > < 1 RA Instructions On Gluing Windscreen|Page 1000