5 Series E34 525td (M51) TOUR
3.
Select Bosch
4.
Label "Diskette 3.1", insert it into the drive on request and confirm with "OK" (2x) --> Setpoint data is copied to
the diskettes.
5.
Insert setpoint data diskette 3.1 into the 3.1 floppy disk drive, insert operating system
diskette 3.0 into the 3.0 drive.
6.
Switch on the machine in the usual manner.
Important:
When creating the KDS diskettes, all data on the diskettes used is overwritten.
Note:
In the event of an error, a corresponding message is shown and the program is cancelled completely. The
procedure must be run from the beginning again and
all data on the diskette will be deleted. A new diskette may have to be used.
12. Creating, copying and editing setpoint data
12.1 Copying
-
Press the "C" button and select the vehicle to be copied.
-
Select the "Edit setpoint data" menu item from the special functions. Create a new vehicle in the usual manner.
The setpoint values for the last vehicle selected will appear in the data input screen. Enter the data and save the
data record.
12.2 Creating
-
Press the "C" button and select the "Edit setpoint data" menu item from the special functions. Create a new
vehicle in the usual manner. An empty data input screen will appear. Enter the data and save the data record.
12.3 Editing
-
Factory-programmed setpoint data can neither be deleted nor modified. If this data does need to be modified, a
new vehicle with modified setpoint data must be created. New vehicles created by the user are identified by a "+
" in the selection menu. These vehicles can be deleted by the user using the "-" key or modified using the "< >"
key. These keys only appear if vehicles have been entered by the user.
13. Special functions
13.1 Customer-specific printer report header
The sub-item "Customer-specific text" must be called up in the "Special functions" menu. An input screen will
appear on the monitor. This input screen must be filled out with the name and address and stored with the "S" screen
key. The text entered is inserted into the report header.
13.2 Adjusting options
-
Call up the "Service" menu in the special functions ("S" key).
-
Select the "Wheel toe adjustment" item or the "Camber adjustment" item from the "Adjustment" sub-menu. The
toe and camber adjustment program will guide the user step by step through the adjustment using text and
images. The measuring deviation for each measuring sensor will be shown on the screen when the adjustment
has been completed.
-
You can store the adjustment values in the measuring sensor using the "Store" key or you can quit the program
with the "Red dot key" without saving them (check). The adjustment values can be printed out.
13.3 Rotating plate test
-
Call up the "Service" menu in the special functions ("S" key).
-
Call up the "Rotating plate" item in the "Service" menu. Turn the left-hand and
right-hand rotating plate and check the display on the screen. Important: The measuring range is
±
306
degrees.
SBT Kinematic Diagnosis System and environment BMW KDS (Beissbarth)
BMW AG - TIS
23.01.2013 11:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 19 -
