5 Series E34 525td (M51) TOUR
Remote control with measured value
display
Cable
Infrared
Setpoint data memory
Floppy disk
Hard disk
Measured value memory
Always the last vehicle measured
Unlimited vehicle memory
Operating system
---
MS-DOS
Languages
English and one language on request
EN, DE, NI, SV, IT, FR, SP (further
languages can be called up)
Update
3.5" floppy disk
3.5" floppy disk using TIS/DIS
Monitor
20"
17"
Computer
---
Pentium
Disk drives
2 x floppy disk
1 x floppy, 1 x CD ROM
10. Control modification (menu)
10.1 Remote control with display
The following steps show how the remote control with display is activated:
1.
Call up the "Service" menu in special functions ("S" key)
2.
Call up the "Remote control" sub-menu in the "Service" menu.
3.
Select the "Remote control with display" item in the "Remote control" sub-menu - this configuration is retained.
Important:
In the case of equipment without remote control, this must be configured to "No remote control".
10.2 Brief operating instructions
1.
Activate the remote control with the "ON" button (it may also be switched on during alignment). The title page will
appear on the LCD.
2.
Select "Straight ahead" of the "Initial measurement", "Adjustment work" or "Final measurement" at the
measuring equipment cabinet. The steering graphics for "Straight ahead" will appear on the LCD.
3.
Use the "Forward arrow" to change to the next measurement image. Display blocks will appear on the LCD with
the designation of the measured value and tolerance bar with the measured value. If the measured value is
within the tolerance range, it is shown in dark figures against a light background. If the measured value is
outside the tolerance range, it will be shown in inverse video (light figures against a dark background).
4.
By pressing the "F" key shortly, you can move alternately between the designation of the measured value and
the setpoint value with the tolerance inside the display blocks.
5.
You can scroll through the measured values using the "Forward arrow", "Backward arrow" and "Cancel" (red
dot) keys. The function of these keys is identical to that of the keys on the graphics panel.
6.
Even with "Free alignment", it is possible to scroll through the measured values in the same way as with "
Program-guided alignment".
7.
During measurement, the report print-out can be initiated using the "Printer" key. The remote control keys are
only active during measurement and adjustment (not during customer data input, vehicle selection etc.).
10.3 Display support
-
Measured values with a setpoint/actual comparison and tolerance bar (setpoint figures can be displayed with the
"F" key)
-
Steering graphics for steering routines
-
Overview of measured values with current setpoint/actual comparison
SBT Kinematic Diagnosis System and environment BMW KDS (Beissbarth)
BMW AG - TIS
23.01.2013 11:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 17 -
