5 Series E39 520i (M52) TOUR
24 11 007
Removing and installing/sealing or replacing
both transmission oil pans (A4S 270R/310R)
Drain automatic transmission fluid.
Unscrew oil sumps.
Remove gaskets and clean sealing faces.
Note:
Bolts are micro-encapsulated and must be replaced after
each removal.
Position seals for oil sump.
Place magnet in large oil pan. Mount oil pans and insert all screws
until contact is made with screw head in each case.
Caution!
Do not tighten screws crosswise and do not tighten screws
any further.
Tighten down screws to torque in sequence in one pass.
Tightening Torque,
refer to Technical Data 24 11 5AZ.
Fluid is poured into the automatic transmission through the filler
opening on the side of the oil pan.
Note:
Car must be unloaded and stationary on a level surface.
Unscrew filler plug (1).
RA Removing and installing/sealing or replacing both transmission oil pans (A4S 270
BMW AG - TIS
03.02.2013 17:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -