5 Series E39 520i (M52TU) SAL
Unfasten brake pipes.
Caution!
Do not mix up brake pipes (mark if necessary before
removal).
Installation:
Pipe connections
(V) from THZ circuit F to hydraulic control unit circuit F (front-axle
circuit)
(R) from THZ circuit R to hydraulic control unit circuit R (rear-axle
circuit)
(FR) from hydraulic control unit FR to front right wheel brake
(FL) from hydraulic control unit FL to front left wheel brake
(RR)from hydraulic control unit RR to rear right wheel brake
(RL) from hydraulic control unit RL to rear left wheel brake
Observe tightening torque,
refer to 34 32 1AZ.
DSC
Unlock and disconnect plug connection (4) on pressure sensor.
Release screw (5) and remove hydraulic control unit; do not bend
brake lines in doing so.
RA Removing and installing/replacing hydraulic unit ABS/ASC+T, DSC3 from 09/98
BMW AG - TIS
05.02.2013 05:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
