5 Series E39 520i (M52TU) SAL
41 62 014
Adjusting trunk lid to fit
Note:
Lids (hood and trunk) are adjusted to fit the unfinished body
shell and are screwed into place.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Trunk lid must lie parallel to both side panels (same seam width)
and should be mounted flush with side panels (tolerance
±
1 mm),
refer to 41 00 - gap sizes for doors / hood and trunk lids,
if necessary, adjust trunk lid to fit, loosening trunk lid lock when
doing so to avoid damage.
Adjust trunk lid to fit:
Press ejector into detent buffer and, in this position, twist slightly to
left with a Phillips screwdriver.
This locks the ejectors in the detent buffers.
Turn out detent buffers.
RA Adjusting trunk lid to fit
BMW AG - TIS
05.02.2013 08:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
