5 Series E39 523i (M52TU) SAL
Install retaining plates.
Install screws with screw retaining compound, refer to BMW Parts
Service, and tighten down.
Tightening torque, 23 11 17AZ.
For replacement of bearing inner race (2), 3rd/4th gear wheel
must be pressed off with special tool 23 2 310 .
For removal, refer to Replacing synchronizing mechanism, 3rd/4th
gear.
Bearing in front housing section.
Drive shaft:
Release screws.
Remove retaining plates (1).
Heat housing in area of ball bearing to approx. 80
°
C (hot-air
blower).
Withdraw ball bearing (2), if necessary drive out with special tool
23 1 440 from outside to inside.
RA Replacing bearings on all transmission shafts (S5D 260Z / 310Z / 320Z)
BMW AG - TIS
14.02.2013 13:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -