5 Series E39 523i (M52TU) TOUR
Ensure that tab (1) is seated correctly.
Tighten screws (2) on outer roller blocks (3) (8.5 Nm).
Installation:
Check and tighten all screws to 8.5 Nm.
Carry out function check:
Raise luggage compartment loading floor (1) at rear
approx. 150 mm and move so that it is parallel over the entire
range of adjustment.
The front rollers (2) on the luggage compartment loading floor (1)
must run without sticking over the entire range of adjustment.
Note:
If the rollers (2) stick:
-
Adjust lateral clearances (C) and (D).
-
Coat rollers (2) with Universal protecting spray (sourcing
reference: BMW Parts Service) (do not use grease).
Place luggage compartment loading floor (1) in position and move
over its normal working travel; no interference noise is permitted
during this process.
Note:
If interference noise occurs:
-
Adjust lateral clearances (A), (C) and (D) and vertical
clearance (E).
Slide in luggage compartment loading floor (1) completely
(locked).
RA Adjusting luggage compartment loading floor (pull-out) (touring)
BMW AG - TIS
16.02.2013 14:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -