5 Series E39 525td (M51) SAL
12 61 250
Removing and installing/replacing oil
temperature switch (M51)
Interrogate fault memory of DDE control unit.
Switch off ignition.
Unfasten oil-filter cover to enable engine oil in filter to flow
back into the oil pan.
Installation:
Screw on oil-filter cover tightly.
Check engine oil level and top up with engine oil if necessary.
Location: On base of oil filter.
Disconnect connector.
Unscrew and remove switch.
Tightening torque,
refer to Technical Data 12 61 1AZ
Installation:
Interrogate fault memory of DDE control unit, check fault
messages in memory, rectify faults and clear the fault
memory.
RA Removing and installing/replacing oil temperature switch (M51)
BMW AG - TIS
19.02.2013 23:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
