bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

ABOUT US
2 RA Removing And Installing_replacing Lock (locking Cylinder) For Trunk Lid Set|Page 1880 > < 1 RA Adjusting Trunk Lid Lock (lower Section Of Trunk Lid Lock)

5 Series E39 525td (M51) SAL

Page 1
background image

51 24 050

Removing and installing/replacing lock
(locking cylinder) for trunk lid set

Remove trim for bottom of trunk lid,

refer to 51 49 005

Unfasten cable tie and disconnect plug connection.

Lift out actuating rod (1).

Unfasten nut and remove connection (2).

Installation:

Check that actuating rod (1) is correctly seated.

Locking section (2) must be fitted to center of body aperture.

Installation:

Perform function check with trunk lid open.

RA  Removing and installing/replacing lock (locking cylinder) for trunk lid set

BMW AG - TIS

20.02.2013  06:28

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Removing And Installing_replacing Lock (locking Cylinder) For Trunk Lid Set|Page 1880 > < 1 RA Adjusting Trunk Lid Lock (lower Section Of Trunk Lid Lock)