bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Adjusting Spray Nozzles For Headlight-cleaning System > < 4 RA Removing And Installing Complete Wiper Console|Page 2335
Page 1
background image

61 67 010

Removing and installing/replacing washer
pump of headlight cleaning system

Remove wheel arch cover at front right top.

Drain fluid tank for windshield washer system.

Note:

When removing, carefully pull out washer pump for headlight
cleaning system so that strainer is not pulled off and thus does not
fall into fluid tank for windshield washer system. If this does
happen, the fluid tank for the windshield washer system must be
removed so that the strainer can be taken out.

Disconnect plug connection (1) in direction of arrow.

Unlock hose (3) and detach in direction of arrow from washer
pump of headlight cleaning system (4).

Turn washer pump of headlight cleaning system (4) in direction of
arrow and pull upwards out of fluid tank for windshield washer
system (2).

Installation:

Make sure hose (3) is laid without kinks.

Replace seal and strainer for washer pump of headlight cleaning
system (4). 

Coat seal with antiseize agent.

RA  Removing and installing/replacing washer pump of headlight cleaning system

BMW AG - TIS

20.02.2013  09:12

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Adjusting Spray Nozzles For Headlight-cleaning System > < 4 RA Removing And Installing Complete Wiper Console|Page 2335