Removing And Installing Engine (M51) for 5 Series E39 525tds
Remove water hoses.
Disconnect coolant hoses to heater at heater separating wall and
at heater valve.
Remove drive belt.
Unfasten a/c compressor from bracket and tie up to one side
(lines remain connected).
Installation:
Remember to fit hollow bushes.
Ensure drive belt is correctly located in grooves of drive gears.
Removing alternator drive belt,
refer to 11 28 010
Unfasten vane pump for power steering unit and tie up to one side
(lines remain connected).
Unfasten reservoir for steering assistance and tie up to one side.
Note:
Lines remain connected.
RA Removing and installing engine (M51)
BMW AG - TIS
20.02.2013 01:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
