5 Series E39 525tds (M51) TOUR
Remove relay (2).
Press down on locking hook with screwdriver and remove relay for
glow plugs (1) by pulling upwards.
Disconnect connector.
Unfasten screw and remove positive lead.
Tightening torque,
refer to Technical Data 12 21 2AZ
Relay is activated by DDE control unit.
Check 80 amp fuse.
If fuse is defective, unfasten screws and replace the fuse.
Tightening torque,
refer to Technical Data 12 21 2AZ
Note:
If fuse has burnt out, trace cause of this fault.
If necessary, check glow plugs,
refer to 12 23 000
RA Removing and installing or replacing relay for heater plugs
BMW AG - TIS
20.02.2013 02:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -