5 Series E39 525tds (M51) TOUR
Important!
E83 M47/T2:
Before the transmission is removed, the output flange with
locking mass (1) must be removed.
Tightening specification must be observed!
Operation is described in Replacing shaft seal for front
differential drive flange.
Identification SAC clutch dia. 240 mm (Self Adjusting Clutch):
-
3 openings each with a pressure piece (1) of adjustment ring
and a pressure spring (2)
Note:
Illustration shows new position of pressure pieces.
4- and 6-cylinder engines:
Block flywheel (1) with special tool 11 2 170 .
8-cylinder engines:
Lock flywheel with special tool 11 2 070 .
RA Removing and installing or replacing clutch (SAC 240 / 4 cyl. M47TU/T2 only, 6,
BMW AG - TIS
20.02.2013 03:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -