5 Series E39 525tds (M51) TOUR
Fit needle bearing and reverse gear wheel.
Fit reverse gear synchronizer ring on reverse gear taper.
Heat 5th/reverse gear guide sleeve to approx. 80
°
C (hot air
blower). Fit output shaft with tapered end (1) facing upwards; if
necessary, press on with special tool 33 1 342 until firmly
seated.
Make sure driver lugs (3) engage in recess (2).
Insert spacer (5) and retaining ring (4).
Retaining ring (4) must be seated without play in groove; if
necessary, replace spacer.
Spacers are available in different thicknesses
In sizes from 3.6 ... 4.0 mm.
Gently knock retaining ring inwards.
Insert 3 thrust pieces (1) and 3 pressure springs (2) in recess in
guide sleeve.
RA Disassembling and assembling all synchronizing mechanisms (S5D 260Z / 310Z / 320
BMW AG - TIS
20.02.2013 04:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -