5 Series E39 525tds (M51) TOUR
Lift out rubber gaiter.
Lift out finisher (1) and pull off cable connector (2).
Unfasten screws and remove position switch (1).
Installation:
Driver pin (2) on position switch (1) must locate in recess on
selector lever (3).
Tightening torque,
refer to Technical Data 25 16 4AZ.
Unfasten screws.
Installation:
Tightening torque,
refer to Technical Data 25 16 3AZ.
RA Removing and installing/replacing shift tower
BMW AG - TIS
20.02.2013 04:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -