5 Series E39 525tds (M51) TOUR
Unfasten screws and remove position switch (1).
Installation:
The driver pin (2) on the position switch (1) must locate in
recess in selector lever (3).
Tightening torque,
refer to Technical Data 25 16 4AZ.
Pull cable connector (1) out of bracket and disconnect.
Unfasten screws and remove shift tower (2).
Installation:
Tightening torque,
refer to Technical Data 25 16 3AZ.
RA Removing and installing/replacing shift tower (Steptronic)
BMW AG - TIS
20.02.2013 04:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -