5 Series E39 525tds (M51) TOUR
32 00 620
Adjusting rear axle (with KDS)
Note:
Any change in camber always involves a change in toe: for
this reason, the camber must always be adjusted first.
Adjust toe-in on eccentric screw swinging arm / rear axle carrier:
Before adjusting, replace disc collar nut (1) and tighten down.
Ensure eccentric washer is correctly located (2).
Tightening torque,
refer to Technical Data 33 32 20AZ.
Loosen disc collar nut 0.5 ... 1 complete turn.
Using the eccentric screw, adjust camber precisely to nominal
value,
refer to Technical Data MG 32.
Tighten down disc collar nut (1). Ensure that eccentric washer (2)
is correctly located.
Tightening torque,
refer to Technical Data 33 32 20AZ.
Caution!
If ever the disc collar nut is tightened more than 10 times
during the alignment check, it must be replaced. The self-
locking effect becomes too slight.
RA Adjusting rear axle (with KDS)
BMW AG - TIS
20.02.2013 05:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -