5 Series E39 525tds (M51) TOUR
34 11 000
Removing and installing/replacing brake
linings of both front disk brakes
Special tools required:
•
34 1 050
•
34 1 080
Note:
After completing work:
-
Fully depress brake pedal several times so that brake
linings contact brake disks.
-
When installing new brake linings at front and rear axles,
brake fluid level must be brought up to "MAX" marking.
-
Hold ignition key for at least 30 seconds in position "1"
without starting engine.
This clears a fault entry in the RAM
This prevents the brake wear indicator lamp from lighting
up again.
Remove wheels.
Refer to 36 10 300.
Lift out retaining spring (1).
Left:
Disconnect plug connection for brake lining wear sensor.
If necessary, replace brake lining wear sensor.
RA Removing and installing/replacing brake linings of both front disk brakes
BMW AG - TIS
20.02.2013 07:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -