5 Series E39 525tds (M51) TOUR
34 21 200
Removing and installing or replacing brake
linings on both rear disk brakes
Special tools required:
•
34 1 050
•
34 1 080
Note:
After completing work:
-
Fully depress brake pedal several times so that brake
linings contact brake disks.
-
When installing new brake linings at front and rear
axles, brake fluid level must be brought up to "MAX"
marking.
-
Hold ignition key for at least 30 seconds in position
"1" without starting engine.
This clears a fault entry in the RAM
This prevents the brake wear indicator lamp from
lighting up again.
Remove wheels.
Remove plastic plugs (1).
Right side:
Disconnect plug connection for brake lining wear sensor.
If necessary, replace brake lining wear sensor.
RA Removing and installing or replacing brake linings on both rear disk brakes
BMW AG - TIS
20.02.2013 07:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -