5 Series E39 525tds (M51) TOUR
34 52 535
Removing and installing/replacing rear ABS
pulse generator (Touring)
Caution!
Note "General Data",
refer to 34 00 ...
Remove wheel,
refer to 36 10 300
Partially unfasten rear wheel arch trim, pull plug connector (1) out
of bracket and disconnect.
Installation:
Ensure proper locking of plug connector.
Pull cable with rubber grommets out of brackets and open cable
ties.
Installation:
Ensure proper seating of rubber grommets and proper routing
of impulse sensor cable.
Unfasten socket head cap screw (1) and pull ABS impulse sensor
(2) out of hole.
Installation:
Clean hole for impulse sensor and grease with lubricating
grease Staburags NBU 12/K (refer to BMW Service Operating
Fluids).
RA Removing and installing/replacing rear ABS pulse generator (Touring)
BMW AG - TIS
20.02.2013 07:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -