5 Series E39 525tds (M51) TOUR
Weld reinforcement for side section / bracket, roller blind.
Grind welding spots until smooth.
Install reinforcement for wheel arch and mark out connection
points.
Remove reinforcement for wheel arch.
Clean and coat connection points with zinc dust paint.
Install shaped part for cavity bulkhead in C-pillar.
Installation of shaped part for cavity bulkhead,
refer to 41 00 ... Installation of shaped parts for cavity bulkheads,
except for cover for side member
refer to 41 00 ...
Install and secure reinforcement for wheel arch.
Weld reinforcement for wheel arch.
Caution!
Burn hazard!
Apply as little heat as possible in area of C-pillar (1) so as not to
damage the layer of adhesive and to prevent the adhesive from
igniting.
Grind welding spots until smooth.
RA Replacing rear left or right wheel arch outer section (side wall removed) (touri
BMW AG - TIS
20.02.2013 09:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -