5 Series E39 525tds (M51) TOUR
41 00 ...
Installing shaped parts for cavity bulkheads,
except for cover for side member
The following repair represents replacement and installation of a
shaped part for the cavity bulkhead of the C-pillar.
When replacing shaped parts in other locations, adopt the
procedure illustrated here and adapt to suit prevailing conditions.
Location of shaped parts,
refer to arrangement of shaped parts in cavity bulkhead.
Further scopes,
refer to Installation of cavity bulkhead for cover for side member,
refer to Installation of a cavity bulkhead with cavity foam.
Before this operation, the spare part to be fitted should be
prepared ready for installation (adjusted to fit, cut to size, coated
with zinc dust paint etc.).
Caution!
The open time of the original BMW window adhesive until a
skin is formed is 30 minutes in a standard climate of 23
°
C
and 50
%
relative humidity.
The open time of the adhesive until a skin is formed is
determined by the relative humidity.
The higher the humidity, the faster the adhesive hardens.
Note:
First clean contact faces of foam residue.
Caution!
If vapors are produced when the foam is removed, these must
be extracted. Ensure the area is well ventilated.
RA Installing shaped parts for cavity bulkheads, except for cover for side member
BMW AG - TIS
20.02.2013 09:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -