5 Series E39 525tds (M51) TOUR
Determine separating point on C-pillar, mark points
A = 190 mm from roof edge
B = 140 mm from roof edge
Connect and separate both points.
Determine separating point on D-pillar, mark out and separate.
A = 140 mm from roof edge
Define, mark out and cut through connection point in cover for
side member.
Dimension (A) = 50 mm of last hole in side member cover
∅
12
mm (1).
Cut out area of reinforcement for jack support connection point
approximately.
Expose and open connection point for D-pillar in water drain.
RA Replacing rear left side wall (part replacement C- and D-pillar, top) (touring)
BMW AG - TIS
20.02.2013 09:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -