5 Series E39 525tds (M51) TOUR
51 11 001
Replacing front bumper
Replacing center section of front bumper (support beam):
Remove complete front bumper.
Remove holder for license plate.
Unfasten screws (1) and lift off air guide (2). In addition, lever air
duct (4) on left/right out of clips (3) and remove.
Lever out expansion rivets (1) and (2) and remove bumper carrier
towards rear.
Note:
Lift out expanding rivets (2) by pulling inwards with pincers.
Version with headlight cleaning system:
If necessary, remove both jet nozzles of headlamp cleaning
system.
If necessary, remove complete water hose.
Installation:
Route water hose under plastic tabs (3).
RA Replacing front bumper
BMW AG - TIS
20.02.2013 09:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -