5 Series E39 525tds (M51) TOUR
Installation:
It is absolutely essential to ensure that the covers of the
welded seams (1 and 2) are fitted. The covers must not reveal
any damage, e.g. sharp edges of welded seams are openly
visible or perceptible.
If necessary, replace damaged covers and eliminate the
cause of the damage!
The ITS head airbag can be damaged by sharp edges when it
is triggered.
This limits the functionality of the ITS head airbag or, in
extreme cases, results in its failure!
View, cover, welded seam, A-pillar
1.
Bracket, water drain, sliding/tilting sunroof, and wire harness,
A-pillar
2.
Cover, welded seam, A-pillar
3.
ITS head airbag
View, cover, welded seam, inside roof frame for B-pillar
1.
Cover, welded seam, inside roof frame for B-pillar
2.
B-pillar
3.
Bracket for front grab handle
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
20.02.2013 16:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -