5 Series E39 528i (M52) SAL
Lift timing chain and hold under tension.
Rotate engine enginewise from the 30
°
before TDC position up to
TDC position.
Hold crankshaft in TDC position with special tool 11 2 300.
Caution!
Remove special tool 11 2 300 before switching on the
engine.
Fit primary timing chain to sprocket.
Fit sprocket to exhaust camshaft with threaded bores on left side
so that it is aligned to the deep bores.
Install special tool 11 4 220.
Screw in the adjusting screw to touch the bow cover, but do not
yet tighten it.
Note:
Long bores in sprocket are now centered.
RA Removing and installing/sealing cylinder head (M52 / S52)
BMW AG - TIS
21.02.2013 15:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
