5 Series E39 528i (M52) SAL
Release guide screws (2) with special tool 34 1 080 .
Installation:
Only clean guide screws; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Tightening torque 34 21 5AZ
.
Lift out retaining spring (3).
Withdraw brake caliper backwards.
Turn piston fully back with special tool 34 1 050 .
Important!
When forcing piston back:
-
Pay attention to brake fluid level in expansion tank; brake
fluid that spills over will damage paintwork.
Remove outer brake lining.
Inner brake lining is located with its spring in the piston.
Important!
Mark any worn brake linings.
If the brake linings are worn on one side, they must not be mixed
up!
New brake linings may only be installed if the brake disk thickness
is greater than or equal to the minimum brake disk thickness (MIN
TH).
Refer to Technical Data.
Observe minimum thickness of brake linings,
refer to Technical Data.
Clean brake linings.
RA Removing and installing or replacing brake linings on both rear disk brakes
BMW AG - TIS
21.02.2013 21:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
