5 Series E39 528i (M52) SAL
41 61 014
Aligning hood lid
Note:
Engine hood was fitted and bolted in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Detent screw on left or right hinge (1) must be set to dimension
(A).
A = 25
±
1 mm
Note:
Detent buffer (2) must not be damaged. Replace hinge if
necessary.
Caution!
Bowden cable on both hood locks must be set to zero
backlash.
Entire sleeve on Bowden cable must locate in guide in lock
otherwise, when release lever is pulled, Bowden cable slips
into guide and it is no longer possible to open locks.
Adjust cable on adjusting fixture to be without play.
Caution!
Cable must not have tension.
RA Aligning hood lid
BMW AG - TIS
21.02.2013 23:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
