5 Series E39 528i (M52TU) SAL
00 11 500
Checking/topping up fluid level in automatic
transmission (GA6HP26Z)
Important!
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
1. Topping up transmission after a repair:
Move selector lever to "P" position.
Stand vehicle on a level surface and secure against rolling off.
Undo filler plug (2).
Installation:
Replace sealing ring.
Tightening torque 24 11 7AZ
.
Top up transmission fluid until it emerges from fluid filling
orifice (2).
Start engine.
Replenish transmission fluid until it emerges from fluid filling
orifice.
Screw in filler plug (2).
Press brake pedal to floor and shift through all gears several times
at idle speed. Then shift to "P" position (Park).
Then check fluid level.
Checking fluid level:
-
Connect BMW Diagnosis and Information System (DIS) or
BMW MoDiC to vehicle.
-
Call up Service functions (drive).
-
Carry out fluid level check in accordance with instructions.
RA Checking/topping up fluid level in automatic transmission (GA6HP26Z)
BMW AG - TIS
20.02.2013 05:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
