5 Series E39 528i (M52TU) SAL
Unfasten screws.
Installation:
Tightening torque,
refer to Technical Data 24 11 1AZ
Remove transmission extension.
Installation:
Install spacer disc (1).
Replace O-ring (2).
If a new output flange or new bearing is installed, adjust end float,
refer to 24 13 156
Clamp special tool 24 1 220 in vise.
Fit transmission extension to the special tool.
Knock back cotter pin in grooved nut.
Installation:
Peen grooved nut to secure.
RA Replacing radial seal for output flange (A5S 310Z)
BMW AG - TIS
20.02.2013 08:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -