5 Series E39 528i (M52TU) TOUR
Remove front rubber mount with special tools
33 3 312 / 314 / 315 and 33 4 162 / 161.
Coat bearing sleeve in rear axle carrier and rubber mount with
Circolight, refer to BMW Parts Service.
Slide rubber mount from side with larger diameter into special tool
33 4 165.
Milled recess (1) makes firm contact with rear axle carrier when
top rubber mount is tightened down.
Caution!
The slotted side of the rubber mount must be at right angles
to the groove in the special tool 33 4 165 and should be
tightened down transversely across the vehicle axis.
Draw rubber mount in firmly with special tool 33 3 314 / 315
and 33 4 164 / 165 / 166. Ensure that special tool
33 4 166 is correctly seated.
Note:
Rubber mount must locate flush in rear axle carrier. If
necessary, rotate special tool 33 4 164 through 90
°
and
draw in overlap.
RA Replacing all rubber mounts for final drive mount
BMW AG - TIS
20.02.2013 17:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -