5 Series E39 528i (M52TU) TOUR
Setting lever without retaining screw:
Inspect to see whether a retaining spring is present.
Press retaining spring at front downwards, raise setting lever (2)
and unhook from sliding rail (3).
Installation:
Install setting lever on left/right on glass sunroof lid. Retaining pin
(1) must locate correctly in bore (2).
Note:
Note designation on right (R) or left (L) setting lever.
Replace screws (1) (microencapsulation) or refit old screws with
Loctite 270 (Sourcing Reference: BMW Parts Service).
Raise setting lever and insert screws (1) as far as they will go (do
not tighten).
Setting lever with retaining screw:
Release retaining screw (2) until assembly opening is free.
Coat protruding thread with Loctite 270 (Sourcing Reference:
BMW Parts Service).
Note:
Hardening of Loctite 270 takes about 30 minutes.
Setting lever with and without retaining screw:
Install glass slide/tilt sunroof lid; in so doing, hook setting lever (1)
at front correctly into sliding rail (2).
RA Removing and installing glass sliding/tilting sunroof lid
BMW AG - TIS
20.02.2013 23:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -