5 Series E39 530d (M57) SAL
Caution!
A small amount of engine oil emerges when the oil pressure
switch is removed.
Have a cleaning cloth ready.
Note:
Illustration shows oil pressure switch on a removed engine.
Disconnect plug connection (1).
Remove oil pressure switch (2).
Installation:
Replace sealing ring.
Tightening Torque,
refer to Technical Data 12 61 1AZ.
Complete vehicle and set in horizontal position.
Start engine and run at idle speed until oil indicator lamp goes out.
Switch off engine. Wait approx. 5 minutes and then check engine
oil level.
Top up engine oil if necessary.
RA Removing and installing/replacing oil pressure switch (M57)
BMW AG - TIS
20.02.2013 12:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -