5 Series E39 535i (M62) SAL
Insert screws in exhaust camshaft on cylinder bank 1 to 4 and
fit without play.
Rotate engine from the 45
°
before TDC position in direction of
rotation up to TDC position.
Hold crankshaft in TDC position with special tool 11 2 300.
Caution!
Remove special tool 11 2 300 before switching on the
engine.
Fit sprocket with chain to inlet camshaft on cylinder bank 1 to 4
with long bores aligned centrally.
Brace sprocket, press bow cover against the timing chain and
check the position of the long bores.
If necessary, remove sprocket once again and align position of
long bores centrally.
Fit sensor gear with mark on sensor gear in cylinder shaft pointing
upwards.
Insert screws and fit flush.
RA Replacing right camshaft (M62 up to 9/98)
BMW AG - TIS
20.02.2013 12:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -