5 Series E39 535i (M62) SAL
Remove clutch slave cylinder, pressure line remains connected.
Caution!
Slowly relieve tension on clutch slave cylinder as otherwise air
will be taken in through sealing sleeve.
Support transmission with a workshop hoist.
Release screws.
Tightening torque, 23 00 1AZ.
Pull out transmission towards rear and remove.
Installation:
Install screws only in conjunction with washers.
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Installation:
Pay attention to dowel sleeves.
Replace damaged dowel sleeves.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
RA Removing and installing transmission (S5D 310Z, M62)
BMW AG - TIS
20.02.2013 14:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
