5 Series E39 540i (M62) SAL
Unfasten screws inside oil pan.
Remove oil pump,
refer to 11 41 000
Unfasten screws to sealing cover.
If necessary, unfasten oil cooler line bracket from oil pan.
Unfasten remaining screws from oil pan.
Lift upper section of oil pan forwards to remove.
Installation:
Sealing faces clean and free of seal debris. Coat edges of
joint with three Bond 1209 sealing compound (refer to BMW
Parts Service).
1.
Replace gasket
2.
Install oil pan
3.
Insert all screws in oil pan.
4.
Insert screws in transmission end without preload at this
stage.
5.
Tighten down screws in engine end.
6.
Tighten down screws in transmission end.
RA Removing and installing/replacing upper section of oil pan (M62)
BMW AG - TIS
20.02.2013 12:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
