5 Series E39 540i (M62) SAL
11 78 510
Replacing oxygen sensor (M62 / S62)
(refer Oper. No. 13 00 002)
Disconnect connector for oxygen sensor.
Unclip Lambda oxygen sensor cable from bracket.
Note:
Use special tool 11 7 020 or special tool 11 7 030 to unfasten
and tighten down the oxygen sensor.
Tightening Torque,
refer to Technical Data 11 78 1AZ.
Installation:
The threads of new oxygen sensors are already coated with
Never Seez Compound.
If an oxygen sensor is used again, apply a thin and event coat
of Never Seez Compound (refer to BMW Parts Service)
to the thread only.
Do not clean the oxygen sensor section jutting into the
exhaust line and do not bring it into contact with lubricant.
Protect (mask) oxygen sensor when applying underseal.
Note cable routing of oxygen sensor.
RA Replacing oxygen sensor (M62 / S62)
BMW AG - TIS
20.02.2013 12:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
